operation load

英 [ˌɒpəˈreɪʃn ləʊd] 美 [ˌɑːpəˈreɪʃn loʊd]

网络  运行负载

化学



双语例句

  1. The interesting analysis is in changed behavior over some other variable like loops over an operation, load placed on the system, etc.
    有意义的分析是随其他变量而变化的行为,这些变量例如有沿着一个操作的循环,对系统所施加的负荷等等。
  2. The Amplifier Circuitry upgraded in several areas to provide more linear output current allowing operation into load impedances other headphone Amplifiers sputter and fuss at.
    耳放中,有多个部件的电路都进行了升级,效果就是能提供更多的线性输出电流,保证负载阻抗的运行(其他放大器在这一点上做得非常不好)。
  3. Speed Control Strategy of Bearingless PMSM by Means of Voltage Regulating Under Flux Enhancing Operation The Load Characteristic Research of Permanent Magnetic Bearing in Small-Scale Wind Turbine
    无轴承永磁同步电机增磁调压转速控制策略小型风力发电机永磁轴承承载特性研究
  4. The Comparison and Analysis of the Stress Deform States of the Integral Rolled Steel Wheels with Different Types of Web Plates under the Operation Load
    运用载荷下不同辐板型式的整体辗钢车轮应力变形状态的比较分析
  5. It can put up a scientific report of operation with variable load in economic safety.
    为机组改带调峰负荷之后的安全经济运行提供合理的科学依据。
  6. The utility model can automatically stop operation when a load has short circuit fault, and simultaneously, the service life of the contact can be raised.
    本实用新型在负载发生短路故障时能自动停止工作,同时能提高触点的使用寿命。
  7. Operation under normal load for a specified period, starting from cold, the intervals after each period of operation being sufficient to allow the equipment to cool down to room temperature.
    常规负载下特定时间段的一种操作,该时间段从冷态开始,到使设备到达室温的间隔。
  8. But after operation, tumor load of the patient was alleviated, immunologic function was restored to normal state, and cellular apoptosis was decreased accordingly.
    但手术后患者肿瘤负荷减轻,免疫功能恢复常态,细胞凋亡率相应降低。
  9. The excited voltage or current harmonics of AC-DC-AC transducer and the stator voltage or current harmonics in the various condition are analyzed according to the experiment in No-load operation and load operation.
    通过交流励磁发电机的空载和并网运行实验,分析了交-直-交变频器输出电压、电流的谐波,对发电机在不同工况下的励磁电流、定子电压电流和转速的谐波进行了分析;
  10. And adding a pre-reformer before the primary reformer, which can increase 10% operation load in safe and stable conditions.
    在一段炉前增设预转化炉可以在安全稳定的情况下提高负荷10%。
  11. It is predicted that the maximum operation load of this reaction system is about 74 g, and the capacity of removal of reaction heats is the controlling step in further increasing its production load.
    预计该反应器最大的可操作负荷为74g左右,影响增产的瓶颈部位在反应系统的移热能力上。
  12. Cause Analysis on the Unstable Operation at Load of Boiler
    锅炉不能稳定带满负荷的原因试验分析
  13. The method, by which the distortion curve can be obtained according to the operation load and the primary curve of flexspline, is introduced.
    导出了柔轮原始曲线、工作载荷与柔轮畸变变形曲线的关系;介绍了根据工作载荷及原始曲线求解柔轮畸变变形曲线的新方法。
  14. The operation of load distribution of boiler and turbine as well as the principle for coordinated control for thermal power generation unit with header are expounded.
    论述了母管制热电机组锅炉、汽机的负荷分配运算和协调控制原理。
  15. The structure, operation, load test and the charging method of AC Delco maintenance-free battery are intro-duced.
    介绍ACDelco免维护蓄电池的结构、使用、负荷试验及充电方法。
  16. Method: by the hospital economic profit and loss forecast technique. Calculate the profit and loss breakeven point between the operation load and the income.
    方法:运用医院经济损益预测技术,计算医院工作量和业务收入损益临界点。
  17. Operation of Load Distribution and Coordinated Control in Power Generation Units With Header
    母管制机组的炉机负荷分配运算与协调控制
  18. The appliance of the two-point multi-section method to infrared multi-band camera showed that the method has the merit of low operation load, high precision and strong practicability.
    在红外多谱段相机上的应用结果表明二点多段非均匀性校正算法具有运算量小、精度高、实用性强的优点。
  19. The polymers are easy to produce in butadiene extraction plant because of the properties of butadiene and extraction solution DMF, so the equipment, pipes and valves are plugged, and the operation load and period are restricted.
    丁二烯抽提装置因其萃取溶剂二甲基甲酰胺及丁二烯本身的特性,在运行过程中易产生各类聚合物,堵塞设备、管线、阀门等,制约装置的运行负荷和周期。
  20. As an important algorithm for speech enhancement, spectral subtraction has less operation load and is convenient for operating efficiently and quickly.
    谱相减算法运算量小、便于快速处理、效果好,是一种重要的语音增强算法。
  21. A self learning control method is applied to optimize performance of internal combustion engine. Self learning is based on feedback data of optimal controlled parameter on different operation load and speed;
    提出了一种可在内燃机电子控制中用于优化内燃机性能的自学习控制方法.这种自学习控制的特点是:当发动机运行工况稳定或变化缓慢时,对发动机进行自适应控制;
  22. Objectives: Predict and estimate the relation of the operation load, cost and income based on the data of 2004 from the certain integrated hospital of Shenzhen City, to discover the problem of the current hospital management and establish the future development strategy.
    目的:预测和评价深圳市某综合医院2004年业务工作量、成本和收益三者之间的关系,以便于医院发现经营管理中存在的问题并制定今后发展的对策。
  23. Experimental results show that when the size of the original searching coverage is 2n+ 1, its operation load is n+ 2 instead of 2n+ 1 of the full-search method, which reduces the computational load greatly.
    当搜索长度为2n+1时,全局搜索算法运算量为2n+1,该算法仅为n+2,运算量显著减少。
  24. The problem of high shaft vibration during generator rotor's 2nd critical speed and exciter rotor's 1st critical speed was always existed since the No. 1 turbine-generator set was commissioned in 1996. The vibration affected the operation of load regulation seriously.
    1号汽轮发电机组自1996年投运以来一直存在发电机、励磁机转子通过其临界转速区域轴振动大的问题,严重影响其调峰运行。
  25. With Trends of Construction machinery to the light-based, multi-functional and high reliability, for the requirements of supporting bearings also will be higher and higher, demand compact structure, stable operation, load capacity, long life, reliable and light weight of supporting bearings.
    随着工程机械向轻型化、多功能和高可靠性的发展趋势,对配套轴承的要求也越来越高,要求配套轴承结构紧凑、运转平稳、载荷容量大、长寿命、可靠和重量轻。
  26. The 3D FEA model was established, and the numerical simulation of sealing process under pre-tightening load and operation load conditions for the double-cone seal structure for 1800~ 3000mm diameter.
    双锥密封结构密封过程数值模拟研究建立了双锥密封系统三维有限元分析模型,对筒体内径1800~3000mm的双锥密封系统在预紧及操作工况下的密封过程进行了数值模拟。
  27. Due to the complicated geometric shape, boundary conditions and operation load of crankshaft, a model that available for accuracy result with the least computing scale has to be created.
    但由于曲轴的几何形状、边界条件和作用载荷都非常复杂,要得到精度足够的结果并保证运算规模适当,建立合理的计算模型是问题关键所在。